so out of curiosity, I plugged the Pro-Micro into my netbook right now.ġ.) It shows/says New Hardware FOund: LeonardoĢ.) In device Manager, I see Yellow ! in several places, (under COM > Arduino Leonardo). (I actually brought my netbook and Pro-Micro to work today, so I can test any feedback on lunch!) (Not sure if this is due to COM enumeration that I read about though?)Īnyone dumb things up a bit and make sense of the results I am getting? I most of the time get COMXX not available? Although other times I do? and it took upload and worked.īut if I click on serial monitor. I edited the sketch changed delay, only used 1 led. it will upload and the TX/RX leds will blink. if I try to upload the default Pro-Micro 'blink' sketch. (I think lastly, currently it shows under the Keyboards as an HID keyboard? I'd have to connect it again to be sure)ī.) The lack of boards in my IDE? How can I get the Pro-Micro +5/+3.3v variants to show up so I can use them to upload? it has installed the Leo, Micro, Pro-Micro drivers on different occasions?Ģ.) Whenever I open up the IDE, and look at the available options under BOARDS > I do not see any +5/+3.3v Pro Micro options in there to choose from?Ī.) The device drivers? What the heck is going on? haha why does it ask to install drivers so many different times? I have the entry in the device manager change several times. and extracted the contents there) (sparkfun > avr > files)ġ.) I have gotten (many times) the prompt to install device drivers. (went to my program files > Arduino directory, created a hardware folder. I downloaded the latest version of the Arduino IDE 1.6.4 I believe it was/is.Īnd grabbed the 'Add-On' files from here: I was using this tutorial as my starter guide: I have a couple, in both +5v and +3.3v versions. and decided on the Pro Micro due to the small form factor/foot print. I have a project that will require one (ATMega32U4).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |